Filter
Top Products
23
P. Setup
1. General Setup Page
1) With no disc inside the player, press ‘SETUP’ to display the Main screen
of the Setup Menu on the screen and “General Setup Page” appears and
“
” is highlighted. Press ‘SETUP’ again to exit the Setup Menu.
2) Press the ENTER button, “TV Display” is highlighted.
3) Press the
or
button to select the other menus in general setup
page.
4) Press to enter the sub menu.
5) Press the
or
button to select the sub menu and press the
ENTER to confirm your selection.
6) Repeat steps 3-5 for other menus.
Note: Press
to return the previous menu.
a) TV Display
Normal/PS: When the player outputs signal to a normal TV, a normal
picture is shown on the full screen.
Normal/LB: When the player outputs signal to a normal TV, a normal
picture is shown on the screen with a black strip at both the top and
bottom of the screen.
Wide: When the player outputs signal to a wide screen TV, a wide
picture is shown on the full screen.
b) Angle Mark
On: The screen will show the angle mark icon. (If an angle option is
available).
Off: The screen will not display the angle mark.
c) Screen Saver
On: Enables screen saver.
Note: The DVD player will enter the Screen Saver mode after ap-
proximately five minutes if the same image remains on the screen.
Off: Disables screen saver.
d) Last Memory
On: The unit will return to the last position on the disc when the tray
is opened or the AV In/Out switch position is changed.
Off: The unit will not return to the last position on the disc.