Filter
Top Products
9
4) Unzip the bag and flip down the front flap. Ensure the retain-
ing Velcro strap of the bag is fastened to prevent the unit
from falling out. Swing the monitor upwards and adjust the
screenfor the desired viewing angle.
3. Installing the system on the back seat in a car (Refer to
Figure 5)
There is no need to remove the four straps from the bag as they
are not used in this installation.
Figure 5
Ensure the rear strap of the bag is attached to the upper Velcro
strip on the back of the bag. Carefully place the system (front
facing up) on the back seat. Guide the vehicle’s safety belt through
the rear piece of the bag. Then secure and adjust the safety belt
so that the system is not free to move around. Swing the monitor
upward and adjust the screen for the desired viewing angle. En-
sure the retaining strap of the bag is fastened to prevent the unit from
falling out.