Filter
Top Products
StorTrends® 3200 Set Up Guide (StorTrends iTX version 2.7)
8
Completing the Hardware Installation
Next, you should check to make sure that the hard disk drives have been properly inserted
and have not come loose in transit.
Step Description
1. Checking the drive
bays
All hard disk drives can be accessed from the front of the server.
Verify that the hard disk drive trays are inserted all the way into its
bay.
2. Check the airflow Airflow is provided by five high-performance fans. The system
component layout was carefully designed to promote sufficient
airflow through the 3U rack mount space. Verify that all cables in
your rack are not obstructing the chassis’s airflow.
3. Connect your
network cable(s)
Plug your Network Cable to both of
these ports or just one of them.
4. Connect your
keyboard and monitor
Plug your Keyboard Here
Plug your Monitor Here
5. Supply power to the
system
The last thing you must do is to provide input power to the system.
Plug the two power cords from the power supply units into a high-
quality power strip that offers protection from electrical noise and
power surges. It is recommended that you use an uninterruptible
power supply (UPS).
Plug your Power into each of
these two power sockets.
6. Power your system
on
Power on by pressing this button.
7. Get the IP address Once the StorTrends® Storage Appliance is fully operational, you
will see the following screen. Write down the IP Address listed in the