Filter
Top Products
Operating Instructions
|
6 Press the “PLAY/PAUSE” button once to start playback of the programmed compilation of
tracks.
To end playback of the compiled tracks press the “STOP” button once. The programmed com-
pilation of tracks continues to be stored and the display continues to indicate “PROG”.
To renew playback of the programmed compilation of tracks press the “PLAY/PAUSE” but-
ton once again.
To switch off the program function press the “STOP” button twice during playback. This ends
the program function, “PROG” is faded out on the display and the programmed compilation of
titles is deleted.
The player is automatically transferred to STOP mode after all programmed tracks have been
played. The programmed tracks continue to be stored until …
• you
open the CD compartment
•
you switch off the player by depressing the “STOP” button
• the MP3-CD player is automatically switched off after 30 seconds.
8.9. Intro play function
The first 10 seconds of all tracks of the loaded CD are played one after the other in the Intro play
function.
Proceed in the following manner to switch on the Intro play function …
1 If a CD is being played, then end playback by pressing the “STOP” button once.
2 Press the “MODE” button three times. “INTRO” appears on the display. Then press the
“PLAY/PAUSE” button once to start the Intro play function.
3 Then press the “PLAY/PAUSE” button once to start the Intro play function.
To end the Intro play function press the “STOP” button once; “INTRO” is faded out on the dis-
play.