Aiwa CSD-ES370 Clock Radio User Manual


 
POWERSUPPLY
Using on AC house current
Before connecting the AC cord (LH model only) *
The LH model has an AC VOLTAGE selector. Make sure that the AC
VOLTAGE selector is set to the position matching your local voltage.
If it is not correctly set, change it with a screwdriver or a similar tool.
Either 110-120V or 220-240V can be selected.
Connect the supplied AC cord. H
Q)
to the AC inlet of the unit
@to a wall outlet
CAUTION
The AC inlet of this set may be connected only with the attached AC
power cord or one recommended by AIWA CO., LTD. Use with others
may result in the risk of fire or damage of AC inlet.
Using on batteries
Insert eight R14 (size C) batteries with the 0 and O marks
correctly aligned. +
Replace batteries when the OPE/BATT indicator becomes dim, the
tape speed slows down, volume decreases, or sound is distorted
during operation.
Make sure that the FUNCTION switch is set to POWER O STANDBY/
TAPE before inserting batteries.
Note on the batteries
Q
Make sure that the ~ and @ marks are correctly aligned.
o Do not mix different types of batteries or old batteries with new ones.
Never recharge the batteries, apply heat to them or take them apart.
. When not using the batteries, remove them to prevent needless
battery wear.
If liquid leaks from the batteries, wipe thoroughly to remove.
REMOTECONTROL(CSD-ES770/ES5700111y)
The remote control can be used only for CD operation.
Buttons on the remote control and the main unit with identical indica-
tions have the same functions.
Inserting batteries
Insert two R6 (size AA) batteries before use.
Replacing batteries
The maximum operation distance of the remote control should be
approximately 5 meters (16 feet). When this distance decreases,
replace the batteries with new ones.
Hints for correct operation
.
When the unit is not to be used for a long period, remove the batteries
to prevent electrolyte leakage.
. Do not expose the light receiving section to direct sunlight or to strong
artificial lighting.
If objects intervene between the light receiving section and the
remote control, the latter may not work correctly.
o The sensor’s light reception range is limited. Point the remote control
toward the recorder when using it.
6