9
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
Troubleshooting
Clock is too dark, hard
to read or doesn’t
work
• The backlight may automatically turn off for 10 minutes
at 2:00am and 3:00am to acquire the atomic clock
signal.
• Verify power adapter is plugged in.
• Check that the batteries are installed correctly. Batteries
may need to be replaced.
• Increase brightness using +/– buttons, located on the
back of the clock.
• The optimum viewing angle for this product is from
slightly above it.
• Reset the unit by unplugging the power supply from the
wall outlet and remove any batteries that are installed.
This will reset the alarm to the original factory settings.
Time and date will need to be entered after a reset.
Inaccurate
temperature
• Make sure the clock is placed out of direct sunlight and
away from any heat sources or vents
(see page 7).
Atomic signal or time
syncing problems
For additional troubleshooting, please visit:
http://www.nist.gov/pml/div688/grp40/radioclocks.cfm