Filter
Top Products
5AccessHD® 7” LCD Panel Television Rev: 09/2009
Getting Started
Follow these steps the first time you use this unit:
1. Retrieve the remote control from the
storage slot located on the back panel
behind the viewing stand.
2. Connect the PSU to the DC
jack on the TV and plug it into
a power socket.
3. Extend the antenna or connect an external antenna. You can also
remove the antenna and plug in an analog cable (in that case you can
skip Steps 5 and 6).
4. Turn the TV power on.
5. Press the Menu button and navigate the TV Setup Menu to the
Channel settings to start a channel scan.
6. Scan channels for 2 to 3 minutes, then navigate up and down through
the channels.
TV Setup Menu Settings
All buttons and controls are described on the board unless otherwise
specified.
After connection, press the Menu button to
enter the TV SETUP menu. Press the
button to move to the desired submenu and
select the setting to adjust. Press Menu to
select it.
Picture Settings
Picture Mode
Press the
button to select Personal, Standard, Dynamic or Soft.
Contrast, Brightness, Sharpness, Tint, Color
Press the
button to adjust the value.
Press the Menu button to return to the previous menu. Press the Menu
button again to exit the TV SETUP menu.