Filter
Top Products
Rev: 09/2009 AccessHD® 7” LCD Panel Television 4
Connecting to External AV Sources
The unit supports an AV signal input function. Use the audio/
video cable to connect the unit to an external audio/
video signal source such as a DVD player, VCR, etc.
Be sure to observe the color code when connecting
audio/video cables. (Cables not included.)
Note: Noise may occur in speakers when there is an
external audio signal input while playing a DVD.
Unplug the audio cord to clear the noise.
Connecting Headphones
Plug headphones into the headphones jack. The
speakers turn off automatically when headphones are
connected. (Headphones not included.)
Note: Excessively loud volume can damage your
hearing. Turn down the volume before you connect
headphone, and then raise the volume to comfortable level.
Using Remote Control
Remove the remote control from the storage slot located on the back
panel behind the viewing stand. Point the remote control unit at the
remote sensor within a range of 5 meters and angles of 60 degrees, and
without obstacles between remote control and remote sensor.
Notes:
Improper use of the battery may cause
overheating, explosion or ignition,
which can result in an injury or a fire.
Battery leakage may damage the
remote control.
Do not expose the remote control unit
to direct sunlight.
Do not recharge, disassemble, deform
or heat the battery.
Do not put the battery in fire or water.
Immediately replace the exhausted
battery.
Remove battery when the remote is not
in use for a long time.
To order a replacement remote
control, go to www.AccessHD.tv