General information
Getting started
Operation
Cleaning
Specifications
Appendix A
Appendix B
Troubleshooting
Printing a card
P420i Plastic Card Printer
Appendix C
A.·MEDIA LOADING ORIENTATION
Position the cards with the Smart Card Chip at the top
of the card and towards the printer.
B.·SMART CARD CONTACT STATION INTERFACE
When a command to the parallel printer interface
sends a card to the Smart Card Contact Station, the
printer connects the Smart Card Contact Station to
the female DB-9 connector on the rear of the
printer.
An attached external Smart Card Programmer can
be used to program Smart card chips
.
DB - 9 SMART CARD DB - 9 SMART CARD
PINS CONTACT POINTS PINS CONTACT POINTS
1 CI (VCC) 6 C6 (Vpp)
2 C2 (Reset) 7 C7 (I/O)
3 C3 (Clock) 8 C8 (RFU)
4 C4 (RFU)
5 C5 (GND)
9 (GND when chip is at station)
Refer to the Card Printer Programmer’s Manual for complete programming information.
DO NOT position printing over the Smart Card Chip.
