Appendixes
Front Panel Controls
Zebra XiIIIPlus Users Guide 85
5(6<1&+02'(
Resynch Mode: Press the right or left black oval to
display other choices.
Default: Feed Mode
Selections: Feed Mode, Error Mode
This parameter determines how the printer reacts if
the label synchronization is lost and the label top is
not where expected.
Feed Mode—If the label top is not where expected,
the printer feeds a blank label to find the label top
position.
Error Mode—If the label top is not where expected,
the printer stops, enters PAUSE Mode, displays the
message (UURU&RQGLWLRQ)HHG/DEHO, flashes
the ERROR LED, and asserts the Service Required
signal (pin 10 on the Applicator Interface
Connector).
To resynch the media to the top of the label in Error
Mode:
1. Press PAUSE to exit Pause Mode.
The ERROR LED stops flashing and the Service
Required signal is deactivated. The action of the
printer is determined by the +HDG&ORVH
configuration selection:
&$/,%5$7,21—determines the length of the
label.
)(('—feeds the labels to the first registration
point.
/(1*7+—used in continuous mode to feed the last
stored label length.
12027,21—the media does not move.
2. You must press FEED to cause the printer to
resynch to the start of the next label if 12
027,21is selected.
3UHVV /&' 'HVFULSWLRQ
