13 Scanning Services
146 Xerox WorkCentre 7232/7242 System Administration Guide
2. A login/password popup will be displayed to authenticate users with the Kerberos
server. Enter the login and password.
The login and password is passed on to the Kerberos server and if a match is found
the user is successfully authenticated.
The user needs to enter a valid login and password for the FTP/SMB server. This may
or may not be the user’s Kerberos login/password, rather it is a login/password that is
accepted by the FTP/SMB server.
When using Network Scanning, Kerberos authentication has the following effect on
the feature:
1. Select [Network Scanning].
2. A login/password popup will be displayed to authenticate users with the Kerberos
server. Enter the login and password.
The login and password is passed on to the Kerberos server and if a match is found
the user is successfully authenticated.
Through the templates/repositories, the users will enter a valid login/password for FTP/
SMB servers. This may or may not be the user login/password; rather it is a login/
password that is accepted by the FTP/SMB server.
Public templates are accessible to any user. Private templates require a password that
may or may not be different from the Kerberos password.
Remote Authentication Network Communication Setup
1. Connect the machine to the network.
2. Press the <Log In/Out> button on the control panel, and then type the Key
Operator login ID to enter the Key Operator mode.
NOTE: The passcode may also be required depending on the machine configuration.
3. Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4. Select [System Settings].
5. Select [Connectivity & Network Setup].
6. Select [Remote Authentication Server Settings].
7. Select [Authentication System], and then select [Change Settings] and choose
[Kerberos (Windows 2000)] or [Kerberos (Solaris)]. Select [Save], if needed.
8. Select [Kerberos Server Settings], then [Kerberos Server 1], and then select
[Change Settings]. Select [Primary Server Name / Address] to enter the IP
address or server name, and then select [Change Settings]. When you entered
the server name, the DNS information needs to be populated through Internet
Services.
9. Select [Primary Server Port Number] and enter the port number. The default is
Port 88.
