Installation Notes
IMPORTANT NOTE: This fryer module must
be installed at least 15" away from any open
flame cooking device.The open flame may
cause ignition of oil.
IMPORTANT NOTE: This fryer module must
be installed at least 15" away from a Wolf
steamer module, as contact between water
and hot oil may cause burns from steam and
hot oil.
Complete installation specifications can be
found on our website, wolfappliance.com.
Unit dimensions may vary by ±
1
/
8
".
Specifications
Exterior Finish Classic
Overall Width 15"
Overall Height 13
1
/2"
Overall Depth 21"
Heating Element 2600 W
Recommended Cabinet Width
one module 18"
two modules 33"
Minimum Cabinet Depth 22
3
/4"
Minimum Height Clearance 13
1
/2"
Countertop Cut-Out Width 14"
Countertop Cut-Out Depth 19
1
/4"
Electrical Requirements 240/208VAC
60 Hz, 15 amp circuit
Conduit 4' flexible 3-wire
Electrical Rating 2.6 kW at 240V
1.9 kW at 208V
Shipping Weight 30 lbs
Installation Specifications
Overall Dimensions
Model IF15/S
Integrated Electric Fryer Module
Dimensions in parentheses are in
millimeters unless otherwise specified.
NOTE: Application shown allows for installation of two 15" (381) modules side-by-side with 33" (838) recommended cabinet width. 18" (457)
recommended cabinet width for installation of single 15" (381) cooktop or module. NOTE: Fryer module must be installed in a base cabinet with
access to manual valve at base of unit to drain oil into heat resistant receptacle. *Minimum clearance from both side edges of cooktop cut-out
to combustible materials up to 18" (457) above countertop. **Minimum clearance from rear edge of cooktop cut-out to combustible materials up
to 18" (457) above countertop.
