13
■ Powdered detergent:
A
Selector in position for powdered detergent
A. Detergent type selector
Chlorine bleach compartment
(Letter D in Dispenser Illustration)
Add no more than
2
/3 cup (160 mL) liquid chlorine bleach to this
compartment. The bleach will be automatically diluted and
dispensed at the optimum time during the first rinse after the wash
cycle. This compartment cannot dilute powdered bleach.
■ Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess.
■ Do not fill beyond the “MAX” level.
NOTE: Overf
illing could cause garment damage.
■ At the end of the cycle, a small amount of water may be left in
the dispenser. This is normal.
Fabric softener compartment
(Letter E in Dispenser Illustration)
Pour measured liquid fabric softener into the fabric softener
dis
penser, if desired.
IMPORTANT: Dilute a
ll fabric softener with water for a total of
1
/4 cup (60 mL).
■ Do not overfill. The dispenser holds
1
/4 cup (60 mL).
■ Do not spill or drip any fabric softener onto the clothes.
NOTES:
■
Use only liquid fabric softener in this dispenser.
Do not use fabric softener dispe
nsing balls in this washer.
Dispensing balls will not operate correctly with this washer.
Pausing or Restarting
1. To pause the washer at any time, press PAUSE/CANCEL.
2. To continue the cycle, press START (for approximately 1 second).
Changing Cycles, Options, and Modifiers
Not all Options and Modifiers are available with all cycles.
Available modifiers will glow amber. If an option or modifier is
una
vailable with a selected cycle, the light will not illuminate.
Cycles, Options, and Modifiers can be changed anytime before
START is selected.
To cancel a cycle and select a new cycle
1. Press PAUSE/CANCEL twice.
2. Pr
ess POWER.
3. Select desir
ed cycle.
4. Select the desir
ed Options or modifiers such as Water Temp,
Spin Speed, and Soil Level.
5. Pr
ess START (for approximately 1 second) to restart the washer
at the beginning of the new cycle.
To cancel a cycle
1. Press PAUSE/CANCEL twice.
2. The washer powers down
, the door unlocks, and clothes can
be removed.
NOTE: If the water level or the te
mperature is too high, the washer
will drain automatically bef
ore the door unlocks.
To change Options or Modifiers after the cycle has
started
1. Press PAUSE/CANCEL once.
2. Se
lect the desired Options or Modifiers such as Water Temp,
Spin Speed, and Soil Level. Available selections will glow amber.
3. Pr
ess START (for approximately 1 second) to continue the cycle.
To drain the washer manually
1. Press PAUSE/CANCEL twice.
2. Pr
ess POWER.
3. Se
lect DRAIN/SPIN.
4. Press START (for approximately 1 second) to begin the drain.
5. When th
e spin is complete, the door unlocks. Items can be
removed from the washer.
Status Lights
These lights show which portion of the cycle the washer is
operating. They also indicate when you can add an additional
item to the wash cycle and when the controls are locked.
Add A Garment
This washer allows a 4-8 minute period in which other garments
may be added to the load. You can add items to the washer if the
Add A Garment status light is glowing.
To add ite
ms when Add A Garment light is glowing
1. Se
lect PAUSE/CANCEL once. The washer door unlocks after
a few seconds, and items can be added.
2. T
o continue the cycle, close the door and select and hold
START (for approximately 1 second).
To add ite
ms when the Add A Garment light is not glowing
1. Y
ou must cancel the current cycle by pressing PAUSE/CANCEL
twice. This will cancel the wash cycle and options. The washer
door unlocks, and items can be added.
2. Close the door
, press POWER, and select the new cycle and
options. Select and hold START (for approximately 1 second).
Done
The Done status light stays on for 60 minutes after the cycle is
complete, and then the washer shuts off.
