Removing the bottom basket . . .
To remove:
1. Lift front of basket up to remove from wall supports.
2. Pull out.
To replace:
I. Position basket in bottom of freezer.
2. Insert basket into wall supports one side at a time.
The key eject lock...
can help reduce the hazard of child
entrapment
To lock or unlock the freezer you must hold the
key tn the lock while turning. The lock is spring
loaded so the key cannot be left in the lock
If the key
IS
lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected
power failure
Signal Light
If the slgnal light is not glowing,
immediately check:
l
for power interruption,
l
the power cord, it may be dlsconnected from
the outlet,
l
the slgnal light, it may be burned out.
Energy saving tips...
You can help your freezer use less electricity
l
Set Temperature Control to provide temperatures
l
Check door gasket and level freezer to assure a
around 0°F ( ~ 17.8 ‘C). There
IS
no need to store
good door seal.
foods below 0°F
l
Clean the condenser coils regularly.
l
Keep door opentngs to a minimum Remove several
items at one time. Keep contents organized to ellmi-
nate searching.
l
Fill to capacity Follow recommended procedures
for freezing foods See pages 8 and 9
l
Keep door locked to ensure door closure.
l
Do not let frost build up to more than % inch (6 mm)
thick. Efficiency
IS
reduced
l
Keep Power Saving Control on OFF when humidity is
low.
To replace burned out signal light:
I. Unplug power cord from outlet.
2. Open the freezer door.
3. Push out signal light from behind, then unplug
burned out light. Replace light with one of
the same wattage and size. Signal light can
be ordered from your WHIRLPOOL dealer,
Part No. 1103639.
4. Close freezer door and plug power cord into
outlet.
6
