The water dispenser
Chilled water comes from a tank behind the
meat drawer. lt holds approximately
1 quart (1 L).
When the refrigerator is first hooked up,
press the water dispenser bar with a glass or
jar until you have drawn and discarded 2 or 3
quarts (1.9 to 2.8 L). Please allow about 30
seconds to clear the air from the system and
for the water to appear. The water you draw
and discard will rinse the tank and pipes.
Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
is designed to evaporate small spills. There is
no drain in this tray. Do not pour water into it.
To dispense water:
1. Press a sturdy glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to
maintain a fresh supply.
The dispenser light
To turn on night light, slide dispenser LIGHT
switch to the left. To replace bulb, reach
through front of dispenser area. Replace bulb
with a 1 O-watt heavy-duty bulb.
WATER
LIGHT
m
Solving common dispenser problems
PROBLEM CAUSE SOLUTIONS
Ice dispenser
l Freezer door open
l Close the freezer door.
won’t work
l Ice bin not properly l Make sure bin is pushed in all the way.
installed
l Wrong ice in bin
l Use only crescents from ice maker.
Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacity.
l Dispenser not used for
l Dump old ice and make a new supply.
extended periods,
causing ice cubes to melt
together
Ice dispenser
l Ice dispenser bar held in 9 Wait about 3 minutes for the dispenser
stops working too long
motor to reset.
l Large amounts of ice should be taken from
the bin, not through the dispenser.
