Programming the AUTO START function on
the remote control
The AUTO START function lets you program the
air conditioner to turn on and cool the room to
a
set temperature at any time you choose-whether
you are home or not.
To program AUTO START:
1. Make sure the clock Is set to the correct
time of day. (See
“Setting the clock on the
remote control” on page 9.)
2. Press the AUTO START SET pad.
NOTE:
If the clock has not been set prior to
pressing the AUTO START SET pad, the
remote control will default to the Clock Set
mode.
3. Use the TIME A (up) or V (down) pads to
set the desired start time.
4. Select an operating mode, fan speed and
temperature.
(See “Starting the air condi-
tioner using the remote control” on page 6 for
more information.)
5. Press the AUTO START SET pad again to
save your program settings.
This example shows the AUTO START
function to be programmed to turn on at
3:00 PM and to use the CCCL mode at HIGH
fan speed to cool the room to 7O’F.
6. Press the AUTO START ON pad to enable
your start time program in the air condi-
tioner. You
will hear a confirmation beep.
NOTE:
Your program is repeated every day at
the set start time. If, at any time, you want to
check or change the program, press the AUTO
START SET pad.
10
