B
w Convert surface burner valves, (all
Oven thermostat adjustment -
models).
Standing Pilot System only
Lift and lock
cooktop in up
position.
Use l/2” wrench
to turn spud
counterclockwise
until snug
(approximately
2-l /2 turns). Do
Not over-tighten.
spuds
increases flame size
(preset at rectory Ior
decreases as
P decreases lame size
C
n
Convert oven burner (all models).
1. Remove bottom oven hold-down screws
at rear of oven bottom. Pull up at rear,
and remove front of oven bottom from
oven front frame. Pull the oven bottom
straight out of the oven. Remove burner
baffle.
2. Use l/2” wrench to turn down the spud
(approximately 2- l/2 turns), until snug
against the pin. Do Not over-tighten.
3. Turn thermostat control knob to 300°F. The
oven burner flame should be steady and
approximately 1’ long with no yellow or
orange tips.
4. If air shutter needs adjusting, loosen
air
shutter set screw and adjust to obtain
proper flame. This will normally be
completely open for L.P. gas. Tighten air
shutter set screw.
5. Replace oven baffle and oven bottom.
If your range is connected to natural gas,
the selector should be turned so the
indicator points to the NAT position. If the
range is connected to L.P. or bottled gas,
the selector should be turned to the L.P.
position.
Allow enough time for the air to escape from
the pilot gas line.
Turn the oven thermostat knob to “Off”.
Remove oven thermostat knob to gain
access to selector key. Light the pilot light.
in off position
L.P. to Natural gas
Converting to natural gas should be done by
a qualified installer.
Use a wrench to remove cap from pressure
regulator. Turn cap over so that the “Nat.”
side is up and replace cap and gasket on
regulator.
Cooktop orifice hoods and oven orifice
hood need to be loosened 2 to 2- l/2 turns
to allow for proper gas flow. The flame
adjustment for cooktop burners and oven
burner would be the same as described in
the installation steps (see Panel C).
If you have a standing pilot system, remove
thermostat knob and use a screwdriver to
rotate key to “N” position. Replace
thermostat knob.
For cleaning and
maintenance...
If removing the range is necessary for
cleaning or maintenance, shut off gas
supply to the range. Disconnect the gas
and electric supply.
If the gas or electrical supply is inaccessible,
lift the range slightly at the front and pull the
range out away from the wall. Pull the
range out only as far as necessary to
disconnect the gas and electric supply lines.
Remove the range to complete cleaning or
maintenance.
Move range back into operating position.
Level the range. Connect gas line to range
and check for leaks. Make sure that cable is
secure in anti-tip bracket. Plug electric
power supply cord into outlet.
Personal Injury Hazard
Do Not step, lean or sit on the range or the
door or drawers of the range.
Failure to follow this instruction could result
in personal injury and/or product damage.
If you need
assistance...
Check your Use and Care Guide for a toll-
free number to call or call the dealer from
whom you purchased this appliance. The
dealer is listed in the Yellow Pages of your
phone directory under “Appliances -
Major. II
When you call, you will need the range
model number and serial number. Both
numbers can be found on the serial/rating
plate located under the maintop.
Part No. 3 16002942/437 1893
01992
Benton
Harbor, Michigan 49022
Printed in U.S.A
