A SERVICE OF

logo

Open as PDF
next previous
12
GM 5000EAC.
C
US
OPERATING MANUAL
EDITION 03/2012 PART NUMBER DOC 2319150
)GNITIONTEMPERATUREOFTHECOATINGMATERIAL
%NSURETHATTHEIGNITIONTEMPERATUREOFTHECOATINGMATERIALISABOVETHEMAXIMUM
SURFACETEMPERATURE
3URFACESPRAYINGELECTROSTATIC
$ONOTSPRAYUNITPARTSWITHELECTROSTATICEGELECTROSTATICSPRAYGUN
-EDIUMSUPPORTINGATOMIZING
4OATOMIZETHEMATERIALUSEONLYWEAKLYOXIDIZINGGASESEGAIR
Cleaning
If there are deposits on the surfaces, the unit may form electrostatic charges. Flames or
sparks can form if there is a discharge.
Remove deposits from the surfaces to maintain conductivity.
Use only a damp cloth to clean the unit.
2.6 GERMAN REGULATIONS AND GUIDELINES
a) BGV A3 Electrical units and equipment
b) BGR 500 Part 2,Chap.2.36 Working with liquid ejection devices
c) BGR 500 Part 2,Chap.2.29 Using coating materials
d) BGR 104 Explosion protection rules
e) TRBS 2153 Avoiding ignition risks
f) BGR 180 Setting up for cleaning with solvents for cleaning workpieces wit
h
solvents
g) ZH 1/406 Guidelines for liquid ejection devices
h) BGI 740 Painting rooms and equipment
j) BGI 764 Electrostatic coating
j) Betr.Sich.V. Plant Safety Ordinance
Note: All titles can be ordered from Heymanns Publishing House in Cologne,or they ar
e
to be found in the Internet.
2.5.3 EXPLOSION PROTECTION IDENTIFICATION FM
For Electrostatic Finishing Applications
using Class I, Group D, Spray Material
In accordance with 2316160
This device has been manufactured and tested according to the FM (Factory Mutual)
standard „Class Number 7260“ (Approval Standard for Electrostatic Finishing Equipment)
by FM. All tested combinations of devices including accessories are given in the FM Control
Document with part number 2316160.
(the device is in submission)