GA 250AL_GA 400AL.
20
X-
"?
OPERATING MANUAL
EDITION 07 /2005 PART NO. DOC0350941
5.3 START-UP
5.3.1 GENERAL RULES FOR HANDLING THE SPRAY GUN
➞
See SAFETY REGULATIONS in Chapter 2
5.3.2 PREPARATION
•
Mount the spraygun on the automatic movement system.
•
Connect material hose to the spraygun and the paint pump.
•
Select and mount the required nozzle.
•
Connect the air hose ø6 mm; 0.24 in / ø4 mm; 0.16 in for the control air to the air
connection of the spraygun.
•
Visually check the permissible pressures for all the system components.
•
Make sure that the spraying unit and all other conductive parts within the work area
are earthed
•
Set material pressure approx. 250 bar; 25 MPa; 3626 psi or 400 bar; 40 MPa; 5800 psi
and use a suitable medium (solvent or water) to check that connections do not leak.
•
Relieve spray gun and unit pressure.
Accessorie Suspension bolt
Part-No. 0350480
3)()??'"
7!2.).'
5NINTENTIONALPUTTINGINTOOPERATION
2ISKOFINJURY
"EFOREALLWORKONTHEUNITINTHEEVENTOFWORKINTERRUPTIONSAND
FUNCTIONALFAULTS
3WITCHOFFTHEENERGYCOMPRESSEDAIRSUPPLY
2ELIEVETHEPRESSUREFROMTHESPRAYGUNANDUNIT
3ECURETHESPRAYGUNAGAINSTACTUATION
"YFUNCTIONALFAULTS)DENTIFYANDCORRECTTHEPROBLEMPROCEED
ASDESCRIBEDINCHAPu4ROUBLESHOOTINGh
3)()??'"
#!54)/.
6ALVEDOESNOTOPENOROPENSONLYWITHONLYLIMITEDACCESS
)NCREASEDWEARONTHEVALVESEATANDNEEDLE
5SEONLYCOMPRESSIONSPRINGFORBAR-0APSIORDERNO4HE
COMPRESSIONSPRINGISMARKEDRED
.EVERUSEACOMPRESSIONSPRINGFORBAR-0APSIORDERNO
