English
14
Spraying
Troubleshooting -
Clean the
Inlet Filter
Start
You will need:
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
IMPORTANT: Make sure your floors and
furnishings are covered with drop cloths
to prevent accidental drips.
1. Unscrew the inlet lter from the tting
on the end of the suction tube.
3. Replace the cleaned lter by
threading it back into the tting on the
end of the suction tube.
Note: If after completing all of the steps
in Spraying Troubleshooting you are still
experiencing problems spraying, refer to
the Troubleshooting section (page 22).
2. Clean the lter using the appropriate
cleaning solution (warm, soapy
water for latex materials, mineral
spirits for oil-based materials).
1
3
2
