FULL SIZE ELECTRIC CONVECTION OVENS - SERVICE PROCEDURES AND ADJUSTMENTS
F25105 (Rev. A, October 2007) Page 24 of 60
DOOR SWITCH ADJUSTMENT
1. Remove the top front cover as outlined under
COVERS AND PANELS in REMOVAL AND
REPLACEMENT OF PARTS.
2. Door operation:
A. Independent doors
- The switch actuator
should be operated by the switch lever
when the right door is between 1" and 1
1/2" from being closed.
B. Simultaneous doors
- The switch actuator
should be operated by the switch lever
when the right door is 1/2" from being
closed.
3. If adjustment is necessary, bend the switch
actuator to obtain the proper setting.
4. Install the top front cover.
5. Apply power to the oven and check for proper
operation.
DOOR CHAIN ADJUSTMENT
(SIMULTANEOUS DOORS)
Introduction
When the oven doors are in proper adjustment, as
the doors come together, the right door will lead the
left door in closing by about 1/4 inch. The doors will
feel like they are self closing the last 1/2 inch of
travel.
Procedure
1. Remove the lower sill cover as outline under
COVERS AND PANELS in REMOVAL AND
REPLACEMENT OF PARTS.
2. Close doors and check door chain for factory
setting.
A. Turnbuckles should be 5 to 5 1/2 inches
apart.
B. Short eye bolt should be connected to the
end of the chain that goes to the front of
the sprocket.
C. 2 links of the chain should not be engaged
at the rear of the sprocket.
D. Chain must be tight enough that the doors
move simultaneously when opened or
closed.
E. When the doors are opened, the
turnbuckles will move away from each
other.
F. The stop cable must be positioned where it
moves freely and does not get pinched.
3. Position door chain assembly to factory setting
if the conditions in step 2 are not met.
4. If right door does not lead the left door in
closing:
A. Loosen locknuts on both turnbuckles.
B. Loosen left turnbuckle.
