Vulcan Materials GHIR44 ML-52210 Manual

A SERVICE OF

next previous

– 12 –

Fig. 15

Questions or concerns regarding the installation procedures may be addressed by calling the Vulcan-

Hart Service Department 1-800-814-2028.

3. Engage union nut on manifold pipe of broiler with the male fitting on the next broiler, and draw

up union hand-tight. Be sure broilers butt both front and rear.

NOTE: Broilers are mounted on a steel, skid-type base, so a crowbar may be used to jockey units. If

the manifolds do not line up, then the broilers are not level.

4. Continue to level up and connect manifold pipe until all broilers in the battery are connected,

then tighten all manifold unions gas-tight.