ViewSonic N4251w
20
ENGLISH
2. Connecting RF antenna and Cable TV
Make sure the power is OFF before installing your LCD TV.
1) Air TV: Connect the LCD TV to TV antenna with 75-ohm coaxial cable. Preset
the air TV channels into memory with Auto Scan function when using an antenna
TV system. This air input jack both support TV and DTV systems.
Besides, the TV system (NTSC) and DTV system (ATSC) can be found by the
scanning of “AIR” in the Auto Scan function. (See page 32.)
Installation
1. Remove the battery cover by pulling then lifting the knob on the cover.
2. Insert the batteries, corresponding to the (+) and (-) markings on the battery compartment.
3. Reattach the battery cover.
1. Insert Remote Control Batteries
CAUTION
Only use the specified AA batteries.
Do not mix new and old batteries. This may result in cracking or leakage, which may
pose a risk of fire or lead to personal injury.
Insert batteries according to (+) and (-) markings. Inserting the batteries incorrectly may
result in cracking or leakage, which may pose a risk of fire or lead to personal injury.
Dispose of the battery in accordance with local laws and regulations.
Keep the battery away from children and pets.
When the remote control will not to be used for an extended period, remove the batteries.
•
•
•
•
•
•
RF Cable or Adapter
(not supplied)
