Auger Control
carefully read and follow all instructions below.
is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged
In a well-ventilated area, start the snow thrower engine. 2.
While standing in the operator’s position (behind the snow 3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten
several times.
5.
walk to the front of the machine.
Confirm that the auger has completely stopped rotating and
of rotating, immediately return to the operator’s position
and shut off the engine. Wait for ALL moving parts to stop
before re-adjusting the auger control.
To readjust the control cable, loosen the upper hex nut on the 7.
8.
downward to increase cable tension).
Retighten the upper hex nut.
achieved.
10 se c t i O n 3— as s e M b l y & se t-up
