A SERVICE OF

logo

1111
Operation
TheusercanentertheSetupModeatanytime(exceptduringtheDiagnosticMode)bypushingbothscrollbuttonsatthesametimeformore
than1second.TheSetupprocedureisasfollows:
Startup Self-Test
WhenyouturntheUPSON,itwillenterDiagnosticModeandperformaself-testlastingabout15seconds.Theresultsoftheself-testare
shownontheLCDscreeninthesequencesbelow.
DIAGNOSTIC MODE
FREQ OUT = XXHz
LCD Screen Message Sequence
(If UPS Is Started with AC Input)
DIAGNOSTIC MODE
FREQ OUT = XXHz
LCD Screen Message Sequence
(If UPS Is “Cold-Started” with No AC Input)
DIAGNOSTIC MODE
INPUT AC OK
DIAGNOSTIC MODE
INPUT AC BAD
DIAGNOSTIC MODE
BATTERY OK
DIAGNOSTIC MODE
BATTERY OK
DIAGNOSTIC MODE
CHARGER OK
DIAGNOSTIC MODE
AC/DC OK
DIAGNOSTIC MODE
AC/DC OK
DIAGNOSTIC MODE
TESTING INVERTER
DIAGNOSTIC MODE
TESTING INVERTER
UPS MODE
LOAD1 = XXX% X.XKW
ON BATTERY MODE
LOAD1 = XXX% X.XKW
Failed Self-Test
Ifaproblemisdetectedduringtheself-test,theLCDwilldisplayanerrormessage.IfyourUPSdisplaysanyofthefollowingmessagesinits
LCD,callTrippLiteTechnicalSupportat(773)869-1234forservice.
BAD BATTERY!
CALL FOR SERVICE
LCD Screen Messages
(If UPS Fails Self-Test)
CHARGER FAILURE!
CALL FOR SERVICE
AC/DC FAILURE!
CALL FOR SERVICE
INVERTER FAILURE!
CALL FOR SERVICE
OUTPUT FAILURE!
CALL FOR SERVICE
FAN FAILURE!
CALL FOR SERVICE
201102170 932611.indd 11 3/30/2011 10:22:16 AM