A SERVICE OF

logo

4 Replacement Procedures 4.35 Fluorescent Lamp
Assembly of outside tape/Cover shield
1. Assembly of Cover shield (S)1.
CAUTION: Pressure or stress should not be given on Source PCB. Usage of gloves with
anti-electric discharge coating is recommended to eliminate possible
damage on circuits occurred by ESD.
2. Assembly of Tape Adhesive2 used for Top case fixing.
CAUTION: Pressure or stress should not be given on Top case during this process.
Figure 4-75 Replacing 14.1-inch LG fluorescent lamp (WXGA) (8)
4-118 [CONFIDENTIAL] TECRA M10 Maintenance Manual (960-685)