Safety and Instruction Decals
The following decals are installed on the machine. If any become damaged or illegible, replace it. The decal part num-
ber is listed below and in your parts catalog. Replacement can be ordered from your Authorized Toro Distributor. For-
eign language decal sets are also available from your Authorized Toro Distributor.
On Drive Shaft Shield
(Part No. 80–8000)
(Part No. 80–8760)
(Part No. 80–8070)
On Muffler Shield (3)
(Part No. 80–8290)
On Each Side Of Engine (2)
(Part No. 80–9350)
On Lift Actuator
(Part No. 80–8010)
On Sides and Behind Rollers (3
(Part No. 80–8090)
On Accumulator body
(Part No. 80–8880)
On Trans. Pump Bracket – under shield
On Top Of Tiller Arm
On Control Panel
On Control Panel
(Part No. 80–8150)
(Part No. 80–8110)
On Drive Shaft Guard
(Part No. 80–8040)
IMPORTANT
D
THE FIVE MICRON FILTER ELEMENT (86–8620) MUST
BE IN PLACE AT ALL TIMES.
D
OPERATION WITHOUT PROPER FILTRATION WILL
RESULT IN PREMATURE WEAR AND FAILURE OF THE
WATER SYSTEM COMPONENTS.
DUSE OF ADDITIONAL FILTRATION OR POTABLE WATER
On Wheel Motor Fork
MAY BE NECESSARY TO PROLONG THE LIFE OF THE
(Part No. 72–4080)
FILTRATION SYSTEM.
DSEE OPERATOR’S MANUAL FOR MORE INFORMATION.
On Underside of Tiller Control Panel
On Each Side Of Machine (2)
On Accumulator body
(Part No. 80–9240)
(Part No. 80–8020)
(Part No. 92–9542)
(Part No. 93–9429)
On Tiller Control Panel
On Tiller Arm
(Part No. 80–8030)
Safety
Page 1 – 4 Rev. B
Hydroject 3000
