10
EN
Preparing a Power Source (continued)
Notes
•During recording, you will hear the beep through the
earphone. During playback, you will hear the beep
through the earphone and the speaker.
•During FF (CUE) or REW (REVIEW), the i lamp may
flash with a beep. Only when the tape does not run
properly, replace the batteries.
•In some cases when the unit is used with rechargeable
batteries, only one BATT/REC lamp will light even
though the batteries have been fully charged.
•After the batteries have been used for a while, the
BATT/REC lamp(s) may flash with the playback
sound when you turn up the volume; however, this
does not mean that you need to replace the batteries.
•The unit will play back normally for a while even after
i lamp flashes with a beep. However, replace the
batteries as soon as you can. If you do not, a loud
noise may be emitted by the built-in speaker or
subsequent recording will not be done correctly.
•When the tape starts running or at the end of the tape
the i lamp may momentarily light with a short beep.
If the lamp goes off, you do not need to replace the
batteries.
