NWZ-X1050/X1051/X1060/X1061
NWZ-X1050/X1051/X1060/X1061
2727
SECTION 4
DIAGRAMS
4-1. SCHEMATIC DIAGRAM
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
• C : Panel designation.
• A : B+ Line.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• Y : Parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
(SIDE B)
Parts face side:
(SIDE A)
Parts on the pattern face side seen
from the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
• MAIN board is muliti-layer printed board.
However, the patterns of intermediate-layers have not been in-
cluded in diagrams.
• Lead layouts
Note 2: When the MAIN board is replaced, there are some notes.
Refer to “NOTE THE MAIN BOARD REPLACING” (page
4) in servicing notes for notes.
Note 1: In this set, only a part of parts that relate to the switch
are supplied. Therefore, the schematic diagram excerpts
and has described only a part. Replace a part according
to “METHOD OF JUDGING RIGHT AND WRONG OF
PARTS RELATED TO SWITCH” (page 7) in servicing
notes. Exchange the entire mounted board when parts that
do not correspond to it are defective.
