90
e flashes in the
display on the
remote control and
the radio does not
operate.
• The rechargeable battery is used up.
, Charge the battery (page 15).
While the recorder is connected to the computer
Symptom Cause/Remedy
The recorder is not
recognized by the
computer.
• The dedicated USB cable is not firmly connected.
, Connect the dedicated USB cable firmly to the recorder and the
computer.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• Network communication has failed.
, Disconnect the dedicated USB cable, wait at least 2 seconds, and
then reconnect it. If the recorder is still not recognized, disconnect
the dedicated USB cable, restart the computer, and then connect the
dedicated USB cable again.
Even though the
recorder is
recognized by the
computer, it does
not operate
normally.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• You are using the recorder at a place with vibration.
, Use the recorder at a place with no vibration.
The recorder cannot
be used as a storage
device.
• The SonicStage or MD Simple Burner software is active.
, Close the SonicStage or MD Simple Burner software.
• A standard disc is inserted.
, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD mode
can be used as a storage media.
The playing time of
a transferred track is
different from the
time that appears on
your computer
monitor.
This is due to a calculation discrepancy between the recorder and the
computer.
You cannot transfer
tracks that will fill
up the remaining
recording time on
the disc.
• The minimum recordable time on a disc is normally 2 seconds in
stereo, 4 seconds in LP2 stereo mode, and 8 seconds in LP4 stereo
mode. When you transfer a track from your computer, the recorder
needs a 2-second (or 4- or 8-second) space for a track even if the track
is under 2 seconds (or 4 or 8 seconds) in length. Also, the recorder
inserts a 2-second (or 4 -or 8-second) space in between tracks during
transfer operation. For this reason, the recorder needs an additional 6
seconds (or 12 or 24 seconds) for each track. This reduces the
maximum recording time for each track by 6 seconds (or 12 or 24
seconds) during transfer operation (in MD mode only).
Symptom Cause/Remedy
