24
Adjusting the microphone sensitivity – ATTEN
Via the “ATTE N” menu, you can adjust the transmitter’s sensitivity.
Adjusting the bass roll-off frequency – LOWCUT
To reduce unwanted low-frequency noise such as wind and handling noise,
you can activate a low-cut filter. The low-cut frequency is 120
Hz.
If you do not want to reduce low-frequency signal portions, select the set-
ting “FLAT”.
Selecting the standard display – VIEW
Via the “VIEW” menu, you can select one of the following standard displays:
The selected standard display is shown
! after switch-on,
! after the menu settings have been displayed for 10 seconds in display
mode.
The sensitivity is correctly adjusted when the level
display for audio signal “AF”
ቨ shows full
deflection only during the loudest passages or
when the r edLED
· lights up brightly.
The sensitivity can be adjusted in 1-dB steps from
+
40 dB to –30 dB.
No t e:
! The bargraph has a resolution of approx. 3 dB
per segment with a display range of 45 dB.
Transmission
frequency “FREQ”
Channel
“CHAN”
Name
“NAME”
dB
AF
RF
ቨ
·
RF
MHz
CH
CH
RF
RF
