English – 33
ENG
How to use OSD Menu
CAMERA SETUP
ZOOM CAMERA SETUP
FOCUS MODE SEMIAUTO
DIGITAL ZOOM ON
IMAGE FLIP OFF
<WHITE BALANCE SETUP>
<AUTO EXPOSURE SETUP>
BACK
EXIT
Setup the general functions of zoom camera module.
FOCUS MODE [AUTO/MANUAL/SEMIAUTO]
Sets camera focus mode.
SEMIAUTO Mode
This mode exchanges focus mode automatically
between Manual Focus mode and Auto Focus
mode. Manual Focus mode activates in preset
operation and Auto Focus mode activates when jog
operation starts.
With Manual mode at presets, Focus data is
memorized in each preset in advance and camera
calls focus data in correspondence with presets as
soon as camera arrives at a preset.
DIGITAL ZOOM [ON/OFF]
Sets digital zoom function to ON/OFF. If this is set to
OFF, optical zoom function runs but zoom function
stops at the end of optical zoom magnifi cation.
IMAGE FLIP [ON/OFF]
To display Upside down image.
White Balance Setup
WB SETUP
WB MODE AUTO
- RED ADJUST ---
- BLUE ADJUST ---
BACK
EXIT
WB MODE [AUTO/MANUAL]
In Manual mode, Red and Blue level can be set up
manually
•
–
•
•
❖
•
RED ADJUST [10~60]
BLUE ADJUST [10~60]
Auto Exposure Setup
AE SETUP
BACKLIGHT OFF
DAY/NIGHT AUTO1
BRIGHTNESS 25
IRIS AUTO
SHUTTER ESC
AGC NORMAL
DNR MIDDLE
SENS-UP OFF
BACK
EXIT
BACKLIGHT [OFF/LOW/MIDDLE/HIGH]
Sets Backlight Compensation
DAY/NIGHT [AUTO1/AUTO2/DAY/NIGHT]
AUTO1 exchanges Day/Night mode faster than
AUTO2.
BRIGHTNESS [0~100]
Adjusts brightness of images. Iris, Shutter
Speed and Gain are adjusted automatically in
correspondence with this value.
IRIS [AUTO/MANUAL(0~100)]
If Iris is set to Auto, Iris should have highest priority
in adjusting AE and Shutter Speed should be
fi xed.
If Iris is set to Manual, Iris should be fi xed and Iris
has lower priority in adjusting AE, in comparison
with others.
SHUTTER Speed
[ESC/A. Flicker/Manual(×128~1/120000 sec)]
If Iris is set to Manual and Shutter Speed is set to
ESC, Shutter Speed should have highest priority.
If Shutter Speed is set to A. Flicker, to remove
Flicker, Shutter Speed should be set to 1/100 sec.
for NTSC and 1/120 for PAL.
AGC [OFF/NORMAL/HIGH]
Enhances image brightness automatically in case
that luminance level of image signal is too low.
DNR [OFF/LOW/MIDDLE/HIGH]
Enhances images by deducting noises when gain
level of images is too high.
•
•
❖
•
•
•
•
•
•
•
