A SERVICE OF

logo

installation & connection
14_ installation & connection
4. Determine the type of power supply and set the POWER SELECTION switch
accordingly. Next, plug the power adapter into a wall outlet.
5. If the camera operates normally, the following screen will be displayed for
5 seconds and then disappears.
6. The requirements for RS485 control is as follows :
- Signaling Speed: 9600 bps
- Data Bit : 8 bits
- Stop Bit : 1 bit
- Parity Bit : none
TYPE 4_ZOM_WDR_P
PROTOCOL SAMSUNG
ADDRESS 0
COMM.TYPE RS485,HALF
BAUD RATE 9600
CAMERA VER. V1.00_090817
LENS OK
EU ENGLISH.indd 14 2009-9-10 13:53:48