174
Using the Command Line Interface (CLI)
Storm Threshold Parameters
Storm Threshold Table
Intra BSS Subscriber Blocking
The following parameters control the Intra BSS traffic feature, which prevent wireless clients that are associated with
the same AP from communicating with each other:
Packet Forwarding Parameters
The following parameters control the Packet Forwarding feature, which redirects wireless traffic to a specific MAC address:
Priority Integer 0 – 255
128 (default)
RW priority
Path Cost Integer 1 – 65535
100 (default)
RW pathcost
State Integer disable
blocking
listening
learning
forwarding
broken
R state
Status Integer enable
disable
RW status
Name Type Values Access CLI Parameter
Storm Threshold Group N/A N/A stmthres
Broadcast Threshold Integer 0 – 255 packets/sec
(default is 0)
RW stmbrdthres
Multicast Threshold Integer 0 – 255 packets/sec
(default is 0)
RW stmmultithres
Name Type Values Access CLI Parameter
Storm Threshold Table Table N/A R stmthrestbl
Table Index Integer 1 = Ethernet
3 = Wireless
R index
Broadcast Threshold Integer 0 – 255 packets/sec
(default is 0)
RW bcast
Multicast Threshold Integer 0 – 255 packets/sec
(default is 0)
RW mcast
Name Type Values Access CLI
Intra BSS Traffic Group N/A R intrabss
Intra BSS Traffic
Operation
Integer passthru (default)
block
RW intrabssoptype
Name Type Values Access CLI
Packet Forwarding MAC
Address
Group N/A R pktfwd
Packet Forwarding MAC
Address
MacAddress User Defined RW pktfwdmacaddr
Packet Forwarding
Status
Integer enable
disable (default)
RW pktfwdstatus
Packet Forwarding
Interface Port
Integer 0 (any) (default)
1 (Ethernet)
2 (WDS 1)
3 (WDS 2)
4 (WDS 3)
5 (WDS 4)
6 (WDS 5)
7 (WDS 6)
RW pktfwdif
