Controlling the rest of your system09
46
En
Chapter 9:
Controlling the rest of your
system
Setting the remote to control
other components
Most components can be assigned to one of
the MULTI CONTROL buttons using the
component’s manufacturer preset code stored
in the remote.
However, please note that there are cases where
only certain functions may be controllable after
assigning the proper preset code, or the codes
for the manufacturer in the remote control will
not work for the model that you are using.
1
Note
• You can cancel or exit any of the steps by
pressing RECEIVER. To go back a step,
press RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1 While pressing the RECEIVER button,
press and hold the 1 button.
The LED blinks.
2 Press the MULTI CONTROL button for the
component you want to control.
The LED lights on continuously.
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 51.
The LED blinks again after you enter the code.
If the correct code has been input the power of
the component being input will turn on or off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the component
type written on each
MULTI CONTROL
button.
2
• Even if you don’t input a preset code for the
TV (TV/SAT MULTI CONTROL button) you
will be able to control your TV using the
dedicated TV CONTROL on the remote if
you have assigned it to the TV CTRL button.
4 Repeat steps 2 through 3 to try a different
code, or to enter a code for another
component you want to control.
5 When you’re done, press RECEIVER.
Note
1• TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CTRL button.
• If you assign the FM or AM function to another component, you will have to reassign it to the Pioneer preset code to use
this receiver’s built-in tuner.
SOURCE
MULTI CONTROL
RECEIVER
INPUT SELECT
DVD/LD
TV/SAT
CD
DVR/VCR
FM AM
RECEIVER
TV CTRL
CD-R/TAPE SIRIUSXM RADIO
F.AUDIO
STANDARD
ADV.SURR
STEREO/
F.
.
RR
AUTO SURR
TUNER DISP
CLASS
MPX
D.ACCESS
MIDNIGHT ANALOG ATT
SIGNAL SB ch
DIMMER SLEEP
DISC
+10
INFO
TV CONTROL
ENTER
2• TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CTRL (+SHIFT)
button.
• You can’t assign the AM / FM or RECEIVER buttons.
09_controlling_system.fm 46 ページ ２００６年１２月１４日 木曜日 午前１０時１分
