![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/3/2f/32f1e40a-68d0-4a61-83a0-26f0aa0a6913/32f1e40a-68d0-4a61-83a0-26f0aa0a6913-bg1e.png)
Listening to your system05
30
En
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the
MULTI CONTROL
buttons (
INPUT
SELECTOR
).
4 Start playback of the component you
selected in step 1.
Choosing the input signal
• Default setting:
AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
1
1 Press
RECEIVER
on the remote control.
2 Press SIGNAL SEL (
SIGNAL SELECT)
to
select the input signal corresponding to the
source component.
Each press cycles through the following:
•
AUTO
– This automatically switches to
DIGITAL
if a digital source is detected,
otherwise it remains on
ANALOG
.
•
ANALOG
– Selects the analog inputs.
•
DIGITAL
– Selects the digital input.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 10), you must select the analog
multichannel inputs for surround sound.
2
• Press
DVD 5.1
(
SHIFT
+
TV CTRL
) on the
remote control or DVD 5.1 on the front panel.
To cancel playback from the multichannel
inputs, use the
INPUT SELECTOR
buttons to
select a different input signal.
Note
1• This receiver can only playback Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other
digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 9) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
2 During playback from the multichannel inputs, you can’t use any of the sound features/modes and only the volume and
channel levels can be set.
VSX_518_KU.book 30 ページ 2008年5月15日 木曜日 午後6時31分