10 Electronic Program Guide (EPG) (for DTV Only)
62
En
Setting the timer manually
Using the menu, you can also preset digital TV pro-
grams by specifying their scheduled date and time.
1
Press HOME MENU.
2
Press / to select “Rec/View Timer”, and then
press ENTER.
• The schedule table appears.
Rec/View Timer
Timer Date Start Stop Channel Target Information
Total:0 Overlap
1
2
3
4
5
6
7
--/--
--/--
--/--
--/--
--/--
--/--
--/--
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
-- : --
---.---
---.---
---.---
---.---
---.---
---.---
---.---
--------
--------
--------
--------
--------
--------
--------
1/4
3
Press / to select a list number, then press .
•You can select any desired list number.
4
Press / to specify a date, and then press .
5
Press / to specify the start hour, and then press
.
6
Press / to specify the start minute, and then
press .
7
Press / to specify the end hour, and then press
.
8
Press / to specify the end minute, and then
press .
9
Press / to specify a channel number, and then
press .
4
Press / to select “ANALOG”, and then press
ENTER.
EPG
******* 10:00 PM – 11:30 PM
*******
*******
Reservation Setting Program View Program Rec
******
Recording Type ANALOG i.LINK
•A dialog box for confirmation appears.
5
Press / to select “OK”, and then press ENTER.
• The program is preset and the schedule table is
restored.
•A red square icon appears for the preset
program.
•A black icon appears for overlapped
presetttings.
6
Press DTV GUIDE to exit the Program Guide.
• Switch on the recording equipment at least 30
seconds before the start of the preset program;
otherwise recording will not be executed.
•Finish presetting operations two minutes before the
start of the program; otherwise presettings may fail.
•For priorities about overlapped presettings, see
“Priority rules for overlapped presettings” on page 63.
• Confirm that the video output terminals on the Media
Receiver have been connected to the signal input
terminals on the VCR to be used for recording.
• If you switch off the system using the POWER
button, the program presetting will become
ineffective. Be careful not to switch off the power.
PDP-ELITE-Eng (57-64) 9/9/03, 11:4662
