En
60
12
Section
Initial Settings
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (REAR SP:FULL) or
subwoofer (REAR SP:S.W) connection. If you
switch rear output setting to the REAR SP:S.W,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (REAR SP:FULL).
When rear output are connected to full range
speakers (when REAR SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in S.W CTRL:INTERNAL or
the auxiliary S.W CTRL:EXTERNAL.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 57) or subwoofer output
(refer to page 57) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press 5 or ∞ to select REAR SP from the
INIT MENU, and press A.MENU.
REAR SP adjustment indications are displayed.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between REAR SP
:FULL (full-range speaker) and REAR.SP :S.W
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select REAR SP:FULL.
• When a subwoofer is connected to the rear
output, set for subwoofer REAR SP:S.W.
• When the rear output setting is REAR SP:S.W,
you cannot change the subwoofer controller.
3 Change the subwoofer controller with
2/3.
Pressing 2/3 will switch between S.W CTRL
:INTERNAL and S.W CTRL:EXTERNAL and that
status will be displayed.
Switching the Telephone
Muting/Attenuation
When a call is made or received using a cellular
telephone connected to this product, you can
select between muting and attenuation when
using the Handsfree Telephone Unit.
1 Press 5 or ∞ to select TEL MUTE/ATT from
the INIT MENU, and press A.MENU.
TEL MUTE/ATT adjustment indications are dis-
played.
2 Switch the telephone muting/attenuation
with 2/3.
Pressing 2/3 will switch between TEL
MUTE/ATT:MUTE (muting),TEL MUTE/ATT:ATT
(attenuation) and TEL MUTE/ATT:NORMAL
(normal) and that status will be displayed.
