Light Status Description
Wireless On Wireless Link is up
Blinking Send / Receive data
Off Wireless signal is disabled
Modem/PC On Connected to a Ethernet Broadband Modem
Off Not connected
Power On Power on, normal operation
Off Power off or failure
Image of rear side explaining ports and buttons
‘5V 1A’ port Connect the included power adapter to this inlet.
‘To Modem/PC’ port Wide Area Network port.
Connect this to your broadband modem
‘Switch’ button Switch this button to change the mode.
- RP: Repeater mode (Default),
- EC: Ethernet Client mode,
- AP: Acces Point
Image of bottom side
‘Reset’ button Press this button for at least 5 seconds to reset the
wireless base station to its factory default settings.
WARNING: THIS WILL DELETE YOUR
CONFIGURATION!
To reset the Wireless Range Extender (WRE)
without losing the configuration settings, see ‘Reset’.
