DIGITAL TUNER
7
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
TUNING
Changing tuning grid (some versions only)
In North and South America the frequency step between adjacent
channels in the AM and FM band are 10 KHz and 100 KHz
respectively. In the rest of the world this step is 9 KHz and
50 KHz. Usually the frequency step has been preset in the factory
for your area.
1. Check that the set is in the TAPE/
OFF position and switched off.
2. To select 9KHz: press simultaneously, PROG and SEARCH §.
Release the controls only when you switch on the set.
• To select 10KHz: press simultaneously, PROG and BAND.
Release the controls only when you switch on the set.
™ When tuning to radio stations, the display shows tuning in
either steps of 9 or 10.
™ All preset stations will be affected and you may need to
reprogramme your presets.
AZ 2030-35 /00
page 7
English
XP AZ 2030/2035/01 01-02-2001 13:05 Pagina 7
