THE BIOSHREDDER DOES NOT IDLE
Please make sure that the cardan joint is connected
directly to the tractor and to the shredder: the
safety locks must be in their appropriate seatings.
If the failure goes on, please call a technician.
STALLING OF THE CUTTING HEADS
BECAUSE OF TOO MUCH MATERIAL
INSERTED OR FOLLOWING THE
ACCIDENTAL INSERTION OF STONES OR
BIG METAL PIECES
(Use the exploded diagram and the list of
components at the end of the manual)
Switch off the engine and wear safety gloves. Open
the door on the left (73) and take out the two spring
washers first (132) and then the two pins for the
sieve (131). Remove the lid of the back protection
housing (125) by unscrewing the 6 nuts (2). At this point you can extract the sieve
(130)
Clean the cutting unit and remove all the residues
of vegetable waste that are still inside
Please handle the hammers in the machine very
carefully (they can cause serious injuries)
Assemble everything again and idle the Bio-
Shredder. Every time, after a stalling of the cutting
unit for the above mentioned reasons, check if the
driving belts and the cutting group still work
correctly and make sure that the blades, the
hammers and the shafts, which are inserted in, are
still integral (see paragraph “Maintenance”)
STALLING OF THE MACHINE BECAUSE
OF STUCKED MATERIAL BETWEEN THE
DRIVING ROLL AND THE ROTOR
Open the door on the right (72) and the one on the
left (73). Unhook the springs (48) by unbolting the
nuts (50). Lift the driving roll (54) and, by using the levers, remove the material
lodged between the rotor (144) and the driving roll (54). Assemble everything again.
STALLING OF THE BIOSHREDDER DUE TO LACKING FUEL IN THE
TRACTOR
Fill the fuel tank of the tractor. Please do not start the machine since the driving belts
Foto6
Foto5
