Problem solving guide
Any work done on the electrical components of this appliance should only
be performed by a qualified and trained person in accordance with all
local and national codes and regulations. Unauthorized repairs may result
in personal injury and damage to the machine.
What to do if, . . . Cause . . . Remedy . . .
. . . The program does not
start?
There is no power.
The “ON” indicator lamp has
not lit up.
Check that..:
– the door is properly closed.
– the machine is plugged in.
– the fuse or circuit breaker has
not tripped.
There is power and the “ON”
indicator lamp is on, but the
program selector has not been
turned to the “Finish / Start”
position.
– Turn the program selector to
the “Finish / Start” position.
– Select a program.
. . . The “Check p / q” indi-
cator lamps are flashing?
The “Check p” indicator lamp
is flashing, and the program
has started.
The water inlet is blocked.
– The inlet valve is not opened
far enough.
– The inlet hose is kinked.
– The water pressure is too low.
Call the Service Dept.
The “Check q” indicator lamp
is flashing.
The drain is blocked.
– Clean the drain pump and lint
trap.
– Has the drain hose been
installed too high? (max drain
height = 4 feet)
Problem solving guide
25
