6. Setting up:
ctivating the Sensor(s):
. Using a screwdriver, unscrew and open the battery cover located at the front of the sensor.
. Insert 2 x AA 1.5V batteries into the battery compartment being sure to observe the correct
polarity marked inside the battery compartment.
teries are inserted, the LCD on the sensor will show the surrounding temperature
and humidity and start transmitting the data to the receiver by 433MHz.
and screw.
ch ct
the battery compartment before replacing the
. Once the batteries are inserted, all the LCD segments will light up briefly before displaying
individual sets of data
r St
This section will describe how to interpret the data as shown on the LCD of the Weather Station. For easy reference, the
A
ecking the corre
1
2
3. Once the bat
4. Replace the battery cover
Activating the Receiver:
1. Flip open the battery cover located at the back of the receiver and
polarization, insert 2 x AA 1.5V batteries into
cover
2
ation: 7. How to use the Weathe
LCD shown here is in full segment.
6
