60
• The node number of the other station and conference which are connected via
EchoLink, or the DTMF code of the control command, etc., are entered into the
EchoLink code.
n Transmitting EchoLink Memory
1 Press and hold the microphone [PTT].
2 While transmitting, press the Tuning control.
• The last called EchoLink DTMF Memory channel name and number appears on
the display.
3 While still transmitting, rotate the Tuning control to select your desired
EchoLink Memory channel, then press the Tuning control to set the
channel.
• The stored code scrolls across the display and is transmitted.
Note:
u In step 2, press the microphone [C] key before pressing the Tuning control, to transmit
the converted DTMF code of the EchoLink “Connect by Call” function. (example: JA1YKX)
“C” “51 21 10 93 52 92 #” (# is automatically added to the end of the DTMF code)
u In step 2, press the microphone [0] [7] keys before pressing the Tuning control, to
transmit the converted DTMF code of the EchoLink “Query by Call” function. (example:
JA1YKX)
“0” “7” “51 21 10 93 52 92 #” (# is automatically added to the end of the DTMF code)
u When only the EchoLink memory name has been registered, the EchoLink “Connect Call”
function transmits the converted DTMF code. (example: JA1YKX)
“C 51 21 10 93 52 92 #” (C is automatically added to the beginning of the DTMF
code and # is automatically added to the end)
u Call Sign/ DTMF Code Conversion Table
When a character other than an alphanumeric character is used (such as “-” and “/”), the
DTMF conversion stops at the character before that non-standard character.
1 2 3 4 5 6 7 8 9 0
0
1 2 3 4 5 6 7 8 9 0
1
Q A D G J M P T W
2
Z B E H K N R U X
3
C F I L O S V Y
n Selecting a Transmit Speed
Some repeaters may not respond correctly if a code is transmitted at fast
speed. If this happens, change the EchoLink transmission speed from FAST
(default) to SLOW.
1 Enter Menu mode and access Menu 205 (ELK.SPD) {page 20}.
