4 ENGLISH
4 Finish the procedure.
Setting the clock
1
Turn on the power.
2 Enter Function Control settings.
3 Turn the control knob to make a
selection, then press to confirm.
1 : 00
4 Adjust the hour.
Preparation
[Hold]
The display demonstration is always turned on
unless you cancel it.
When you turn on the power (or after you reset
the unit), the display shows:
“CANCEL”
=
“DEMO”
=
“PRESS”
=
“VOL KNOB”
• If no operation is done for about 15 seconds,
“DEMO START” appears and the display
demonstration starts.
To cancel the display demonstration:
1
Press the control knob.
“NO/<YES>” is shown on the display.
2
Press the control knob again to select
“YES”.
“DEMO OFF” appears on the display.
• If “NO” is selected, “DEMO START”
appears and the display demonstration
starts.
You can also cancel the display demonstration
from the Function Control settings, see the
following:
Canceling the display
demonstration
1
Turn on the power.
2 Enter Function Control settings.
3 Turn the control knob to make a
selection, then press to confirm.
EN02-11_KDV-MP3346M[U]f.indd 4EN02-11_KDV-MP3346M[U]f.indd 4 11/19/09 4:44:16 PM11/19/09 4:44:16 PM
