4
Controls
Operations of the following control and switches are required in accordance with
the center unit and speakers connected with this unit.
KAC-526X
1
RCA cable ground lead terminal
2
FILTER switch
These switches allow filtering of the speaker output signals.
• LPF (Low Pass Filter) position
Only frequencies of 80 Hz or lower are output. (Frequencies above 80 Hz are cut.)
The Lch and Rch will be mixed before output even if the operation switch is set to STEREO.
• OFF position
The original sound without filtering is output.
3
OPERATION switch
This switch allows selection of the amplification method of input signals.
• STEREO position
The amplifier can be used as a stereo amplifier.
• MONO (Lch) position
Amplifies the signal input from the left side only. Set to this position and make bridged
connections to use as a high-power monaural amplifier. (The input right signal is not output.)
4
INPUT SENSITIVITY control
Set this control according to the pre-output level of the center unit
connected with this unit, or to the maximum power output of the genuine-
accessory car stereo.
Use the diagram on the right as a guide.
