Receiver operation
12
“Pseudo-Stereo" can be used to simulate a “stereo-like“ effect with mono pro-
grammes, and should thus only be activated with mono reception.
If Pseudo-Stereo has been turned “On“, the stereo width can no longer be altered.
Muting the sound
The unit is in normal mode (TV or radio mode).
•
Press the
key.
The sound is muted, allowing you to make a phone call undisturbed, for example.
In the OSD, Sound off is displayed for approximately 3 seconds. In the LED display
the sound muting is shown by means of 3 dots. After changing programme, the
message
Sound off is displayed again.
•
If you press the
key again the sound is turned back on.
Note
Mute is not operative at the VCR Scart socket.
Stereo- / Mono- / Channel changeover
TV broadcasts can be transmitted in the two-tone channel method
(e.g. original tone “English" on channel 1, “German" tone on channel 2).
•
Press the
key. Each time you press the key, you switch the sound channel in
the order,
Sound channel 1 → Sound channel 2 → Stereo.
The selected channel is shown on the screen and in the LED display. The setting is
not saved. After a change in programme the original setting takes effect again.
SAT/TV changeover
Where the satellite receiver and TV set are connected via a Scart cable, many
older TV sets immediately switchover signal input (on the Scart socket) to video re-
ception when the satellite receiver is turned on. The switching voltage of the TV
Scart socket therefore needs to be switched off if you want to view a terrestrially
broadcast TV programme..
•
Press the
key.
The switching voltage on pin 8 of the TV Scart socket is turned off, and it is turned
on again by pressing once more.
In TV mode, “
TV mode
“ is displayed on the screen, the programme slot indicator in
the LED display begins with “
T
...“.
In Sat mode, “
Sat mode
“ is displayed on the screen, the programme slot indicator
in the LED display begins with “
P
...“.
Setting date and time
The unit is in normal mode (TV or radio mode)
•
Press the
key to call up the menu for date and time setting, and turning the
continuous time display on/off.
