Sat measurement
Frequency Display and Entering Frequency
To measure the level of a received signal, you must first enter the desired
frequency. The LC display shows the frequency and the measured level.
You can enter frequency values from 920 MHz to 2150 MHz in steps of
100 kHz.
Overview of commands in Entering Frequency (SAT)
[SAT/TV] Switch over to SAT reception
[0]...[9] Enter frequency
[+] [-] You can alter frequency in steps of 100 kHz
[ENTER] Confirm entry
LC display:
• Frequency: 1288 MHz
• Mode: SAT
• Level: 66.5 dBìV
Example
Enter frequency 1508 MHz
Press [1] [5] [0] [8] [ENTER]
LC display:
• Frequency: 1508 MHz
• Mode: SAT
• Level: 86.5 dBìV
A + or – in the display means that MSK 24 has not been tuned in exactly
to the desired carrier. Use the [+] and [-] buttons to adjust the frequency
for the best possible reception. When a vertical line appears in the
display, the frequency has the best possible setting.
Note
Press [ENTER] to complete the frequency entry.
The last frequency setting is retained even when the MSK 24 is switched
off provided it was made using "numerical entries" and concluded with
"MHz".
FR:1288.0MHz SAT
LEV: 66.5dBuV
LEV: 86.5dBuV
