52 – English
Repair instructions
7.29 Replacing the bar bolt
Replacing the front bar guide.
1
Drain the oil tank.
2
Knock through the old guide bar bolt so that it falls
into the oil tank.
3
Remove the bolt from the oil tank.
4
Secure steel wire to the outer part of the bar bolt
(A), thread the steel wire through the oil tank and
out through the bolt hole in the crankcase (see
gure 70).
5
Pull the steel wire so the bolt comes out of its hole
(see gure 71).
6
Check that the bolt's square head ts in
the washer (D) which is positioned in the cut-out in
the crankcase.
7
Pull out the bar bolt with its nut. Place a spacer
between the nut and crankcase (see gure 71).
8
Rell with chain oil.
Replacing the rear bar guide
1
Pull out the bar guide (C) with the help of slip-joint
pliers (see gure 70).
2
Fit the bar guide with the help of a hammer.
Fig 70
Fig 71
