20
8
SET MODE
D Battery voltage indicator “bt”
This function controls display or non-display settings of the
connected battery pack’s voltage when the power is ON.
•
The voltage of the connected battery pack is displayed for 2 sec.
after power is turned ON.
D Signal strength indicator “Sl”
The signal strength indicator displays received signal strength
as “S-meter”. This function is convenient to check the signal
strength visually.
•
The strength is displayed at 4 steps.
• The antenna mark and 3 bars appear when receiving strong signals.
• The antenna mark only appears when receiving no signal.
D Squelch sensitivity function “SS”
When this function is turned ON, blocking against noise is im-
proved. Therefore the squelch is not easily affected by noise.
D Scrambler code “cd”
There are 32 codes (1 to 32) available for programming. In
order to understand each other, all transceivers in your group
must share the same scrambler code.
